Site Overlay


In this case, please double check: The Setup program allows users to modify the basic system configuration. Main Panel contains features as follows: By SPD default , Manual. Exit Without Saving Abandon all changes made during the current session and exit setup. In this panel, you can get the real-time status information of your system. System only boots from optical drive.

Uploader: Zuluzuru
Date Added: 9 October 2014
File Size: 16.78 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 12141
Price: Free* [*Free Regsitration Required]

Biostar 865GV Micro 478 Drivers

Manual Aside from the paperback manual, we also provide manual in the Driver CD. Fast gives faster performance; and Slow gives more stable performance. On default Numpad is number keys. Yes defaultNo. Typematic Rate Setting When a key is held down, the keystroke will repeat at a rate 856gv by the keyboard controller. Keyboard lights are on, power indicator lights are lit, and hard drive is spinning. Indicator light on keyboard does not turn on.

Warranty will be void if the pin protection cap is not in place to protect the CPU socket pin when sending this mainboard for service.

However, if any program writes to this memory area, a system error may result.

If install and FDC or 865gf system has no floppy drive, select Disabled in this field. Unlock a DIMM slot by pressing the retaining clips outward. TM2 Bus Ratio Represents the frequency.


This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

Biostar 865GV Micro 478 Owner’s Manual

The IDE connectors can connect a master and a slave drive, so you can connect up to two hard disk drives. This action will boot-up the system according to FSB of the processor. Suspend Type Select the Suspend Type. Modes 0 to 4 will increased performance progressively.

The rest of this manual is intended to guide you through the process of configuring your system using Setup. Delay 4 Sec, Instant-Off default. Enabled defaultDisabled USB 2. Plug in the power cord and boot up the system. When you see the following dialog in setup procedure, it soind setup is completed. In this panel, you can get the real-time status information of your system.

Overclock Panel Click the Overclock button in Main Panel, the button will be highlighted and the Overclock Panel will slide out to left as the following figure.

Drivers For Free – Biostar Intel Socket gv Micro Audio and Sound Drivers

CPU Overheated If the system shutdown automatically after power on system for seconds, that means the CPU protection function has been activated. Pull the lever sideways away from the socket and then raise the lever up to a degree angle.


The default settings that came with your system have been optimized and therefore should not be changed unless you are suspicious that the settings have been changed incorrectly.

Onboard Serial Port 1 Select an address and corresponding interrupt for the first 685gv second serial ports.

The CPU will fit only in the correct orientation. Registered memory are not supported.

Biostar GV Micro Owner’s Manual – Page 1 of 67 |

The vendor makes no representations or warranties with respect to the contents here and specially disclaims any implied 865gg of merchantability or fitness for any purpose. Item Options Date mm: User Defined default Allows you to set each mode individually.

Make sure power cable is securely plugged in. Remove AC power line.

If you have change the setting, you must let the system boot up until it goes to the operating system, before this function will work. Driver Installation To install the driver, please click on the Driver icon.